![]() ![]() Enable Wake-on-LAN in the BIOS settings. ![]() If you plan to use Wake-on-LAN, you need to enable it on the remote computers by following these steps: ![]() It means that to use the Wake-on-LAN technology, the computer you need to wake up should be configured to enable WOL. Besides, to wake up a computer, the receiver should listen to network packets, so the network card should be turned on even if you turn the computer off. To uniquely identify the target computer, a sender uses the unique MAC address of the network card of the receiver. Wake-on-LAN (WOL) is a technology supported by hardware that allows waking up computers by sending a specific network packet to them. In this chapter, you can see how to configure and use Wake-on-LAN. However, Wake-on-LAN is a specific operation because it is based on using the hardware technology to wake up computers, so it has a few specific requirements. You can use the same principles to configure and execute different operations. In the previous chapters, you could see how to configure and execute operations remotely. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
May 2023
Categories |